AT3510 Tilt Sensor

General Description

The Atmodule AT3510 series are two axis precision digital-output angle sensors. The module incorporates a two-axis electrolytic tilt sensor, sensor interface electronics, and a sensor signal processor. Smart drive techniques are used to eliminate warm-up drift and long term drift which are normally seen with electrolytic sensors.

Operating from a standard five-volt power supply, the module is designed for board mounting with 6-pin header connection. An acrylic coating protects the electronic circuitry. The module is intended for cost sensitive OEM applications that require good null accuracy and repeatability.

Features

• ± 75 or ±30 degrees measurement range
• 0.02 degree resolution
• 0.05 degree repeatability
• 120 mS conversion time
• 1 mS data access time
• Digital temperature compensation and calibration
  of null (zero)
• Single supply operation 4.75 to 5.25 volts
• 14-bit A/D conversion
• Setup and calibration data is stored in non-volatile
• EEPROM memory, with hardware write protection
• Electronic serial number and calibration date
  

Applications

• OEM tilt measurement
• Robotics
• Strap down angle measurement
• Wheel alignment

Datasheet

AT3510.pdf

< Back to Products

The Atmos AT3510 Tilt Sensor